Category Archives: Complacency

Poor choice of knot puts pilot in jeopardy

Initial report While boarding a vessel at sea a pilot found that the combination ladder was affixed solely by overhand knots (see pictures) . These easily unravel if there is strain from the standing part of the rope, e.g., under the weight of a pilot as they ascend or descend the ladder. This type of […]

Touching bottom while berthing causes rudder damage

Initial report A loaded tanker (14m draft) entered harbour and approached its berth. The bridge and mooring stations were fully crewed. The pilot embarked and a comprehensive master-pilot exchange took place. All equipment was reported in good condition and working. Two tugs were made fast – one at the bow and one at the stern. […]

Handover follow up

Initial Report A time-constrained handover took place on board a tanker at anchor the evening prior to a planned canal transit. The off-signing crew of 21, who had been on board for 11 months, were relieved by a complement of 14; the remainder scheduled to join at the next port. Over the following weeks the […]

Cargo damage due to water ingress into cargo hold No. 5

Initial Report A cargo vessel went to anchor and commenced pumping out ballast water from No1C Water Ballast Tank (WBT) to adjust its trim before a canal transit the following day. Shortly before pumping was completed, the bilge alarm for cargo hold No. 5 WBT activated. The Chief Officer instructed an ordinary seaman to take […]

Steering gear malfunction

Initial Report As a container ship was conducting outbound pilotage, the bridge team noticed a delay in response of the steering gear. At the same time, they noticed an alarm indicating “EMERGENCY – XX, SERVO LOOP”. The steering gear was in manual mode operated by Follow-Up (FU) No. 1 and No. 2 system control units. […]

Fatigue in the international towage sector

Initial report “Our work levels continue to be high regardless of the awful impact of COVID and this is further increased by a lack of manning. Some vessels are non-operational due to a variety of reasons causing additional workload on the operational tugs and the crews that man them.” The reporter stated that the fatigue […]

Lifeboat on-load cable release unit defect

Initial report During an annual lifeboat safety inspection it was discovered that the on-load cable release could not easily be moved, and the release lever required extreme force to operate. The forward hook cable release also did not operate properly. A replacement cable release arrangement was procured locally, and repeated tests were conducted to confirm […]